Apple 13-0010--001 User Manual

task, considering the vivid imagination of many 

users.

These instructions have been written in a step-

by—step manner, with some explanation of what is 

being done at each step. All of these instruc— 

tions have been tested at Rana to confirm that 

they are correct. In addition, several “early 

release” and later users also confirmed the 

accuracy of these instructions. Therefore,   

there is no reason for you not having complete 

success following these instructions. That is, 

if’ you follow the instructions completely, step 

by step. You are encouraged to read these in-

structions completely, all the way through, 

before starting the procedure. That way you   

will have a general understanding of what all is 

involved before “diving in”.

The first thing to do is to “digup” your DOS 3.3 

master diskette which has Apple’s MASTER    

CREATE utility on it. (If you’re a CP/M or  

Pascal user, you’ll find your DOS diskettes 

buried in the bottom left hand corner of the 

closet, on top of the DOS 3.2.1 diskettes.)

These instructions are going to assume that you 

have your (first) controller card in slot six, 

and your (first) drive attached as drive one  

(you won’t get very far having your only drive 

connected as drive’ two). If your drive is not 

connected in this manner, and you are not an old 

hand at using Apple DOS, then you should prob-

ably rearrange your system into this configura-

tion for the duration of the enhancing proced-

ure.