Xerox 8855/721P User Manual
7
Location of the Stacker Serial Number
In order to locate the serial number of your stacker, you must first
push down the release lever and slide the stacker away from the
printer.
push down the release lever and slide the stacker away from the
printer.
The serial number plate is located on the left of the front cover facing
the printer.
the printer.
Stacker Operation
If you are running paper larger than a 24” (610mm) raise the paper
supports.
supports.
In order to turn on your stacker, press the power switch to the on
position. When the stacker is on the green Power Indicator Light is
visible.
position. When the stacker is on the green Power Indicator Light is
visible.
NOTE: There is no start up sequence between the stacker and the
printer (either the stacker or the printer may be turned on first). If
your stacker does not run, turn off both the printer and the stacker.
Turn on the stacker then turn on the printer. If the stacker still does
not function, verify power source and then call for service.
printer (either the stacker or the printer may be turned on first). If
your stacker does not run, turn off both the printer and the stacker.
Turn on the stacker then turn on the printer. If the stacker still does
not function, verify power source and then call for service.
Stacker Jam Clearance
The paper fed from the printer will be either cut or uncut.
Caution
To ensure the safety of the user, be aware during jam
clearance that the surface will be hot.
clearance that the surface will be hot.
Cut
In order to clear a jam in the stacker, lift the Upper Panel Assembly
and clear any paper (Figure 2). If the jam still exists, push down on
the release lever and move the stacker away from the printer (Figure
1). Clear any visible paper from the paper path.
and clear any paper (Figure 2). If the jam still exists, push down on
the release lever and move the stacker away from the printer (Figure
1). Clear any visible paper from the paper path.
Uncut
Cut the paper in the printer (refer to the printer user guide) and follow
the above procedure.
the above procedure.
NOTE; The Transmission PWB and the Reception PWB are infrared
connections (See Identifying the Parts on the Stacker). To ensure
proper operation of the stacker, these connections must be debris
free.
connections (See Identifying the Parts on the Stacker). To ensure
proper operation of the stacker, these connections must be debris
free.
Serial Number Plate
Caution Hot Label
Jam Clearance Label
Jam Clearance Label
Figure 1. Sliding the Stacker away from the Printer.
Figure 2. Lifting the Upper Panel Assembly.
Upper Panel Assembly