Planar M70L User Manual

Aspect Ratio Settings

42

m70L Installation & Configuration Guide

Justify determines how the picture will be placed in a wall of displays. For a single 
display, Justify determines placement on the screen. If the image is not large enough 
to fill all the displays in the wall, some will be left blank.

Positions the image starting with the top, leftmost display, then across and down. 

Positions the image starting with the center of the image in the center of the wall 
spreading out equally to all displays.

Positions the image starting with the bottom, rightmost display, then across and up.

This is used to hide blank areas and stray lines in the edges of an image. The lower 
the overscan setting, the more of the optical image that is seen. Planar displays have 
a default overscan of 3% for S-Video and composite video images. Standard CRT 
televisions have an overscan of about 5%, which may actually hide content or images 
that you want to see. 

These show the number of displays wide and high for the picture. This may be 
different from the physical size of the wall. You could build a 4 x 3 array of displays 
and use 

WALL

 

MODE

 to put a single picture on the four displays in the upper left 

corner, for instance.

These represent the position of the display in this “array.” For example, in the 4 x 3 
array of displays shown below, Unit numbering starts at the top left corner of the 
array. This display would have a Unit Column value of 

1

 and a Unit Row value of 

1

.

When checked, this turns on the Planar Big Picture™ feature. When not checked, the 
display shows the whole picture.