Intel AXXRSBBU6 User Manual

4. Remove the protective metal cover from the battery connector on the RAID controller

card. (J10 on the Intel

SRCSASBB8I and Intel

SRCSASLS4I.)

5. On the Intel

RAID Controller SRCSASBB8I and the Intel

RAID Controller

SRCSASLS4I, place the RAID controller with the components facing up.

Figure 2. Battery alignment on the add-in Intel

RAID Controllers

6. Hold the AXXRSBBU6 so that the battery side is up and the three screw holes align.

Figure 3. Battery board mounting on RAID controller board

7. Place the three standoffs (#6 in Figure 1) between the two cards in the three screw holes.

8. Carefully press the AXXRSBBU6 onto the RAID controller, so that the two connectors

shown in Figure 3 are firmly joined.

• On the Intel

RAID Controller SRCSASBB8I and the Intel

SRCSASLS4I, use the

J10 connector.

9. Secure the AXXRSBBU6 to the RAID controller with the 6 provided Phillips (2-56)

screws (#5 in Figure 1). The standoffs are threaded at both ends and a 2-56 screw goes
into each end. (Place 3 in from the battery side and 3 in from the RAID controller side.)