abit AN9 32X User Manual
2.6.2 Serial ATA Connectors
Each SATA connector serves as one single channel to connect one SATA device by a thin SATA
cable.
cable.
The RAID 0/1/0+1/5/JBOD configuration is also possible through the combination of disk arrays
through these SATA connectors:
through these SATA connectors:
To connect SATA device:
1. Attach either end of the signal cable to
the SATA connector on motherboard.
Attach the other end to SATA device.
Attach the other end to SATA device.
2. Attach the SATA power cable to the
SATA device and connect the other end
from the power supply.
from the power supply.
The motherboard in this illustration is served for demonstration only, may not be the same type
or model as the one described in this user’s manual.
or model as the one described in this user’s manual.
2-20