DELL 1950 User Manual
About Your System
17
LCD Status Messages
The system's control panel LCD provides status messages to signify when the system is operating correctly
or when the system needs attention.
or when the system needs attention.
The LCD lights blue to indicate a normal operating condition, and lights amber to indicate an error
condition. The LCD scrolls a message that includes a status code followed by descriptive text. Table 1-7 lists
the LCD status messages that can occur and the probable cause for each message. The LCD messages refer
to events recorded in the System Event Log (SEL). For information on the SEL and configuring system
management settings, see the systems management software documentation.
condition. The LCD scrolls a message that includes a status code followed by descriptive text. Table 1-7 lists
the LCD status messages that can occur and the probable cause for each message. The LCD messages refer
to events recorded in the System Event Log (SEL). For information on the SEL and configuring system
management settings, see the systems management software documentation.
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
NOTE:
If your system fails to boot, press the System ID button for at least five seconds until an error code
appears on the LCD. Record the code, then see "Getting Help" on page 125.
Table 1-7.
LCD Status Messages
Code
Text
Causes
Corrective Actions
N/A
SYSTEM NAME
A 62-character string that can be
defined by the user in the System
Setup program.
defined by the user in the System
Setup program.
The SYSTEM NAME displays
under the following conditions:
under the following conditions:
• The system is powered on.
• The power is off and active
POST errors are displayed.
This message is for information
only.
only.
You can change the system string
in the System Setup program. See
"Using the System Setup Program"
on page 31.
in the System Setup program. See
"Using the System Setup Program"
on page 31.
E1000
FAILSAFE, Call
Support
E1114
Temp Ambient
Ambient system temperature is out
of acceptable range.
of acceptable range.
E1116
Temp Memory
Memory has exceeded acceptable
temperature and has been disabled
to prevent damage to the
components.
temperature and has been disabled
to prevent damage to the
components.
E12nn
xx PwrGd
Specified voltage regulator has
failed.
failed.
E1210
CMOS Batt
CMOS battery is missing, or the
voltage is out of acceptable range.
voltage is out of acceptable range.