Emerson ATCA-9305 User Manual

 MPC8548 Environment 

ATCA-9305 User’s Manual

Press the ‘s’ key on the keyboard during reset to force the default monitor environment vari-
ables to be loaded during hardware initialization but before diagnostic testing.

Table 9-6:

115200

Console port baud rate
Valid rates: 9600, 14400, 19200, 38400, 57600, 115200

-1

This sets the time-out in seconds for the BMC watchdog 
before booting the OS. If set to -1, then the BMC watchdog 
is disabled before booting the OS.
Valid options: -1, 1-65535

" "

Command to execute when auto-booting or executing the 
‘bootd’ command

1

Choose the number of seconds the Monitor counts down 
before booting user application code
Valid options: time in seconds, -1 to disable autoboot

" "

Path to boot file on server (used with TFTP)—set this to 
“path/file.bin” to specify filename and location of the file to 
load.

-1

Set the number of seconds the Monitor counts down before 
booting user application code (used only with autoboot). If 
the boot commands fails, it will try again after bootretry 
seconds.
Valid options: time in seconds, -1 to disable bootretry

h

Press during power-up/reset initialization to terminate the 
monitor autoboot sequence and go to the monitor prompt.

on

Select whether to clear unused SDRAM (memory used by 
monitor is excluded) on power-up and reset. 
Valid options: on, off

on

Enables the processor L1 data cache
Valid options: on, off

on

Enable ECC initialization—all of memory is cleared during 
ECC initialization.  Valid options: on, off

off

Select the reporting of single bit, correctable ECC errors to 
the console (errors of 2 or more bits are always reported) 
Valid options: on, off

00:80:F9:
97:00:00-
00:80:F9:
97:FF:FF

ATCA-9305 board Ethernet address for TSEC_1 port, the last 
digits are the board serial number in hex.