Emerson ATCA-9305 User Manual

 Troubleshooting

ATCA-9305 User’s Manual

Insert a board:

1

Insert the ATCA-9305 into an available slot. 

2

Push in the front panel handle (tab).

The blue Hot Swap LED on the front panel (see 

) flashes a long blink to indicate that 

board insertion is in progress and system management software is activating the slot. Then 
the blue LED turns off, indicating the insertion process is complete, and payload power is 
present.

Remove a board:

1

Pull out the handle (tab) on the ATCA-9305 front panel one click.

A short blink indicates the board is requesting permission for extraction. 

2

Remove the board when the blue LED on the front panel is on (no payload power).

Caution:

Do not remove the ATCA-9305 while the blue LED is blinking.

In case of difficulty, use the following checklist:

  Be sure the ATCA-9305 circuit board is seated firmly in the carrier.
  Be sure the system is not overheating.
  Check the cables and connectors to be certain they are secure.
  Check that your terminal is connected to a console port.

If you need help resolving a problem with your ATCA-9305, visit 
http://www.emersonembeddedcomputing.com/ on the internet or send E-mail to sup-
port@artesyncp.com. Please have the following information handy:

• ATCA-9305 serial number and product identification (see 

• MPC8548 monitor version number (see 

)

• Cavium monitor version number (see 

• version and part number of the operating system (if applicable)

!