Emerson PMC-CGM User Manual
Safety Notes
PMC-CGM Installation and Use (6806800D53C)
15
Emerson and our suppliers take significant steps to ensure there are no bent pins on the
backplane or connector damage to the boards prior to leaving the factory. Bent pins
caused by improper installation or by inserting boards with damaged connectors could
void the Emerson warranty for the backplane or boards.
backplane or connector damage to the boards prior to leaving the factory. Bent pins
caused by improper installation or by inserting boards with damaged connectors could
void the Emerson warranty for the backplane or boards.
Configuration Switches
Malfunction of the Product
Switches marked as "Reserved" might carry production-related functions and can cause
the product to malfunction if their setting is changed.
Therefore, do not change settings of switches marked as "reserved".
Switches marked as "Reserved" might carry production-related functions and can cause
the product to malfunction if their setting is changed.
Therefore, do not change settings of switches marked as "reserved".
Damage of the Product
Setting/resetting the switches during operation can cause damage of the product.
Therefore, check and change switch settings before you install the product.
Setting/resetting the switches during operation can cause damage of the product.
Therefore, check and change switch settings before you install the product.
Cabling and Connectors
Product
Damage
The RJ-45 connector(s) on the face plate are BITS interfaces. Connecting a telephone to
such a connector may destroy your telephone as well as the product.
Make sure that BITS connectors near your working area are clearly marked as network
connectors. In addition, observe the following safety notes:
such a connector may destroy your telephone as well as the product.
Make sure that BITS connectors near your working area are clearly marked as network
connectors. In addition, observe the following safety notes:
z
Verify that the length of an electric cable connected to a BITS bushing does not
exceed 100 m.
exceed 100 m.
z
Make sure the BITS bushing of the system is connected only to Telecommunication
Network Voltage level 1 (TNV-1) circuits.
Network Voltage level 1 (TNV-1) circuits.
If in doubt, ask your system administrator.
Environment
Always dispose of used modules, system components and RTMs according to your
country’s legislation and manufacturer’s instructions.
country’s legislation and manufacturer’s instructions.