Siig PCI 4S User Manual

5.

Change  JP1-JP4 jumper settings to the desired

voltage only if your serial device(s) needs additional

power from the serial port.  However, most serial

devices do not require additional power.  For more

information, see Figure 1 on page 2.  Skip this step

if power is not required.

6.

To install the card, carefully align the card's bus

connector with the selected PCI slot on the

motherboard. Push the board down firmly, but

gently, until it is well seated.

7.

Replace the slot bracket's holding screw to secure

the card.

8.

Replace the computer cover and reconnect the power

cord.

9.

Connect the 4-port fan-out cable to the board's

44-pin connector.  For more information, see Figure

2 on page 3.

This section provides information on how to install the

CyberPro PCI 4S drivers.

1.

At the Update Device Driver Wizard window, click

Next.

2.

Insert the driver CD, and click Other Locations.

Type in D:\9x, click OK, then Finish. (Change D: to

match your CD-ROM drive letter)

3.

From the Insert Disk window, click OK.  When the

Copying Files dialog box appears, type in

D:\9x, then click OK.

4.

Restart Windows to complete the installation.