Addonics Technologies RTM4R5EU3 User Manual

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)   

Phone: 408-453-6212 

Email: www.addonics.com/support/query/

 

f. 

Press the RAID setting button with a ball point pen.

 

g. 

While pressing the RAID setting button turn on the system power  

 

 

where the HPM is connected. The buzzer will sound while holding the  

 

 

RAID setting button. Release it after at least 5 seconds for hardware  

 

 

initialization. A single beep will be heard to indicate initialization is  

  completed. 

 

h. 

Verify if the RAID array is detected by the system.

 

i. 

If the 5-port HPM-XA is connected to the motherboard onboard  

 

 

SATA, on the CMOS setup utility, the raid array will display as  

 

 

“Addonics H/W RAID5” if setup as a RAID5 array.

 

j. 

If the 5-port HPM-XA is connected to an eSATA host controller card,  

 

 

on the RAID BIOS, the raid array will display as “Addonics H/W  

 

 

RAID0” if setup as a RAID0 array.

 

k. 

If booted into Windows, in Disk Drives under Device Manager, the  

 

 

raid array will display as “Addonics H/W LARGE” if setup as a  

  LARGE 

array.

 

l. 

Once raid array is verified, you can set the buzzer either ON or OFF.

1      2      3      4      5

1      2      3      4      5

When 2 drives are 

connected to the HPM-XA, 

and DIP switch is set to this 

setting, the 2 drives will be 

configured as a 2-drive 

RAID1 array.

Clone’s action is similar to 

RAID1. However, all of the 

hard drives will be mirrored. 

Clone mode is useful 

especially when users like 

to copy data from a source 

hard drive to the drives 

connected to the HPM-XA.

When 4 drives are connected to the HPM-XA, the 4 drives will be 

configured as a 4-drive RAID10 array.