Maxon Telecom MM-6280IND User Manual
Extended AT Commands Manual
Page 20 of 70
2009-06-25
Command TE2
Æ
MT2
$$RESET
Response
TE2
Å
MT2
$$RESET: 1 | 0 (Success | Failure)
Note:
Using the new format with the old firmware R1.1.17 will cause the modem
to hang. For older firmware (R1.1.17 please use AT$$RESET=n where n is in
minutes)
5.1.1.6.
Current time (AT$$TIME)
This command enables the user to view the current date, time and day.
Table 5-20 Read command
Table 5-20 Read command
Command TE2
Æ
MT2
$$TIME
Response
TE2
Å
MT2
$$TIME: <yyyy-mm-dd,HH:MM:SS,sss(Day of Week)>
Value
sss: milliseconds
Day of Week: SUN, MON, TUE, WED, THU, FRI, SAT
Day of Week: SUN, MON, TUE, WED, THU, FRI, SAT
5.1.1.7.
Software version (AT$$SWVER)
This command enables the user to view the MT2 software version.
Table 5-21 Read command
Table 5-21 Read command
Command TE2
Æ
MT2
$$SWVER?
Response
TE2
Å
MT2 $$SWVER:
<software_version>
Example
software_version: (example: CHM628 R1.1.18 [Jul 09 2007 15:35:17])
5.2. Power Conservation Commands
5.2.1.1.
Sleep mode control (AT$$SLEEP_ENABLE)
This command is used for control of the Sleep mode of the engine. This is useful to reduce the
current draw for power conservation applications. The engine constantly cycles through
‘sleep’/‘idle’ modes when value is 1. This setting has no effect on the ability of the MT2 to MT or
MO calls.
Table 5-22 Read command
current draw for power conservation applications. The engine constantly cycles through
‘sleep’/‘idle’ modes when value is 1. This setting has no effect on the ability of the MT2 to MT or
MO calls.
Table 5-22 Read command
Command TE2
Æ
MT2
$$SLEEP_ENABLE?
Response
TE2
Å
MT2 $$SLEEP_ENABLE:
<value>
Value:
0: Sleep mode disable
1: Sleep mode enable (Default)
1: Sleep mode enable (Default)
Table Error! No text of specified style in document.-23 Set command
Command TE2
Æ
MT2
$$SLEEP_ENABLE=<value>
Response
TE2
Å
MT2
$$SLEEP_ENABLE: <value><result_code> (OK | ERROR)