Multi Tech Equipment MT5634ZBA-V-V92 User Manual
3 Operation
16
MultiModemZBA-V-V92 User Guide
Leased Line Operation
The MultiModemZBA-V-V92 modem can be used on a two-wire leased line.
A leased line is a private, permanent, telephone connection between two points. Unlike normal dialup
connections, a leased line is always active. The modems automatically connect when they are
attached to the line and are turned on. Because a leased line is always active, one of the two
modems on the line must be configured as the originate modem and the other as the answer modem;
however, it does not matter which is which.
connections, a leased line is always active. The modems automatically connect when they are
attached to the line and are turned on. Because a leased line is always active, one of the two
modems on the line must be configured as the originate modem and the other as the answer modem;
however, it does not matter which is which.
In the event of an interruption, leased line modems automatically reconnect when the data line or
power is restored.
power is restored.
Setup
1.
Open the modem and change jumper J10 to select leased-line operation, and jumper 11 to select
either originate or answer operation, depending on how you intend to use the modem. See
Chapter 2 for the detailed procedure.
Chapter 2 for the detailed procedure.
2.
Connect a modular telephone cable to the LINE jack. Connect the other end of the cable to a
two-wire leased line jack or terminals supplied by the telephone company.
3.
Turn on the modem.
4.
This completes the setup for two-wire leased line operation. Upon completion, the modem
attempts to connect to the modem at the other end of the leased line. If the remote modem has
not yet been configured for leased line operation, you may turn off the local modem until the
remote one is ready.
not yet been configured for leased line operation, you may turn off the local modem until the
remote one is ready.