Multi-Tech Systems MTCBA-E-EN User Manual
Appendix C – Firmware Upgrade Using External TFTP Client
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F)
55
Appendix C – Firmware Upgrade
Using External TFTP Client
Follow the steps below to install new firmware from the Multi-Tech Systems, Inc. Web site:
Obtaining the Latest Firmware Version
To obtain the latest version of the firmware, contact you Multi-Tech Sales Representative or contact Multi-Tech
To obtain the latest version of the firmware, contact you Multi-Tech Sales Representative or contact Multi-Tech
directly by phone or email:
Phone: 763-785-3500 or 800-328-9717
See the Multi-Tech Web site:
www.multitech.com
1.
Open the modem/router’s Web Management software using a Web Browser. Enter the Gateway Address
http://192.168.2.1
(default) and complete the login.
2.
Go to the IP Setup > General Configuration screen and check the Enable button for Firmware Upgrade
under the TFTP Configuration at the button of the screen.
under the TFTP Configuration at the button of the screen.
3.
Click Save & Restart located on the Menu bar.
4.
Then open the DOS screen by clicking the PC’s Start button and selecting Programs > Accessories >
Command Prompt
Command Prompt
.
5.
At the C: prompt, enter the upload request by typing the following:
tftp -i <ip-address> put <firmware-filename>-tftp.bin AMD-tftp.bin
Then press Enter.
Then press Enter.
Example:
tftp -i 192.168.254.253 put c:\example.bin (Press Enter)
Definitions of the Upload Request Parameters:
Definitions of the Upload Request Parameters:
•
<ip-address>
Address of the Serial-to-Ethernet Adapter to which you are uploading the firmware image.
•
<firmware filename>
Filename under which the firmware file was saved on your PC or local network.
•
AMD-tftp.bin <>
. This is a case-sensitive file name; type it as shown here.
6.
After the upgrade is completed, open the Web Management software to see if the new version shows.