Multi Tech Equipment ISIHI-2S User Manual

Carriage Return Character
Unit: Decimal ASCII code
Range: 0–127
Default: 13 (^M)

Specifies the character used by the TA to indicate the end of a command line.

Line Feed Character
Unit: Decimal ASCII code
Range: 0–127
Default: 10 (^J)

Specifies the character used by the TA to indicate the end of a status message.

Backspace Character
Unit: Decimal ASCII code
Range: 0–32, 127
Default: 8 (^H)

Specifies the character used by the TA to delete the previous character in command line.

 Wait for Connection (Abort Timer)
Unit: 1 second
Range: 0–255
Default: 45

S

ets Abort Timer delay time, which is the length of time TA waits for a connection after

dialing. If no connection is established during the specified time, the TA ends the call.

DCD Drop Time
Unit: 50 ms
Range: 0–254, 255
Default: 20

Sets the amount of time the DCD signal will be dropped when a call is disconnected if the
DCD signal is configured for a momemtary drop on disconnect (&C2)

DTR Drop Time
Unit: 100 ms
Range: 0, 1–255
Default: 5

Sets the time that DTR must remain low before the TA disconnects. The 

S25

 unit value

for 0 is 40 ms. For values from 1 through 255, the unit value is 100 ms.

Escape Sequence Timeout
Unit: 100 ms
Range: 0–255
Default: 20

Sets the time allowed in an escape sequence from the receipt of the 

A 

in 

AT 

to the receipt

of the carriage return. If the 

time interval expires before you press E

NTER

, the escape

sequence ends. The default time is 2 seconds.