AirLink X EV-DO User Manual
33
Modbus/BSAP Configuration
FIGURE 5.
Wireless Ace: Addr List
Addresses can be entered in decimal or hex. Wireless Ace will translate hex entries into decimal.
The number before the “=” is ID, the number after is the IP address. There can be a total of 100
remote ID/Local addresses entered into the modem.
The number before the “=” is ID, the number after is the IP address. There can be a total of 100
remote ID/Local addresses entered into the modem.
When using AT commands via telnet or direct serial connection, use ATMLIST for decimal IDs
and ATMLISTX for hexidecimal, ex. if the ID is 27 and the IP is 123.123.123.124, you would
enter it as ATMLIST27=123.123.123.124 or ATMLISTX1B=123.123.123.124.
and ATMLISTX for hexidecimal, ex. if the ID is 27 and the IP is 123.123.123.124, you would
enter it as ATMLIST27=123.123.123.124 or ATMLISTX1B=123.123.123.124.
Dynamic IP
If you do not have a static IP, the host modem should be configured to report its current IP to a
Dynamic DNS (DDNS) server with IP Manager (page 11).
Dynamic DNS (DDNS) server with IP Manager (page 11).
In the Host modem’s configuration, instead of IP address for the Addr List (ATMLIST or ATM-
LISTX), substitute a single unique name for each modem, i.e. remote1, remote2, etc.
LISTX), substitute a single unique name for each modem, i.e. remote1, remote2, etc.
When you configure IP Manager for the host modem, make note of your modem name and domain
setting in Wireless Ace in the menu selection Dynamic IP to be used with the remote modems.
setting in Wireless Ace in the menu selection Dynamic IP to be used with the remote modems.
FIGURE 6.
Wireless Ace: Modem Name and Domain