IBM 388 User Manual
1. Locate the failing hot-swap redundant power supply module on the rear of your server. Then, press the
release tab
1
in the direction as shown and carefully pull the handle
2
at the same time to slide the
redundant power supply module out of the chassis.
Note: Do not use too much strength. You can first carefully slide the redundant power supply module a
little bit out to release it from the secured position. Then, completely slide it out of the chassis.
little bit out to release it from the secured position. Then, completely slide it out of the chassis.
Figure 80. Removing a hot-swap redundant power supply module
2. Touch the static-protective package that contains the new hot-swap redundant power supply module
to any unpainted surface on the outside of the server. Then, remove the new hot-swap redundant
power supply module from the package.
power supply module from the package.
142
ThinkServer User Guide