IBM 4400 User Manual

Page of 316
36
Chapter
2
Configuring the P-Series Emulation with Control Codes
Character Set Select: ECMA-94 Latin 1 Extended
ASCII Code SFCC OSET;
n
Purpose
Selects the Extended Character Set and the print mode and
pitch at which the extended character prints. Valid only in the
ECMA-94 Latin 1 Extended Character Set; otherwise, this
command is ignored.
Comment
n ranges from 0 through 12 (hex 00 through hex 0C) to select the
print mode/pitch combinations available from page 52. All other
values result in an error message. In OSET mode, values
outside the range in Table 6 produce an error message.
(Command Line Error Messages are listed in Table 2 on page
27.
)
Extended characters print at the print mode and pitch selected
by the OSET command, even if that mode and pitch differs from
the currently selected print mode and pitch. If the print mode
differs between the extended and primary characters, the first
character in the data stream selects the print mode at which that
line prints. Different pitches can be printed on the same line.
Table 6. Print Modes/Pitches Available Using P-Series OSET
(ECMA Latin 1, Extended Character Set Only)
n
Print Mode/Pitch Select
0
Barcode Letter Gothic 10 cpi
1
Multinational Letter Gothic 10 cpi
2
Multinational Letter Gothic 12 cpi
3
Multinational Courier 10 cpi
4
Greek Letter Gothic 10 cpi
5
Greek Letter Gothic 12 cpi
6
Greek Courier 10 cpi
7
Graphics Letter Gothic 10 cpi
8
Graphics Courier 10 cpi
9
Scientific Letter Gothic 10 cpi
10
Scientific Letter Gothic 12 cpi
11
Scientific Courier 10 cpi
12
Multinational at Primary Character Set Mode and Pitch