IBM 4400 User Manual
46
Chapter
2
Configuring the P-Series Emulation with Control Codes
Line Spacing 1/6 Inch (6 lpi)
ASCII Code SFCC 2
SFCC LPI;
n
Hex Code
SFCC 32
Dec Code
SFCC 50
Purpose
Sets line spacing to 6 lpi or as set by SFCC A.
Comment
For SFCC LPI;
n, the value of n can be 6 or 8 only. If n = 6, this
command sets line spacing to 1/6 inch. Values of
n other than 6
or 8 causes an error message. (Command Line Error Messages
are listed in Table 2 on page 27.)
are listed in Table 2 on page 27.)
SFCC 2 asserts
n/72-inch line spacing as set by SFCC A (page
49). If no distance has been set by SFCC A, the distance is 1/6
inch.
inch.
The control code line spacing selection overrides the control
panel line spacing setting.
panel line spacing setting.
Example
The following example illustrates 1/6-inch line spacing and
assumes that a distance has not been set by SFCC A.
assumes that a distance has not been set by SFCC A.