IBM T400S User Manual
Table 4. Beep symptoms (continued)
Symptom or error
FRU or action, in sequence
One long and two short beeps, and a blank or unreadable
LCD.
LCD.
1. System board.
2. LCD assembly.
3. DIMM.
2. LCD assembly.
3. DIMM.
Two short beeps with error codes.
POST error. See Numeric error codes.
Two short beeps and a blank screen.
1. System board.
2. DIMM.
2. DIMM.
Two or more beeps, or a continuous beep. Operating
system starts successfully.
system starts successfully.
If a mini-PCI Ethernet card is installed, confirm that Alert
On LAN 2 in BIOS Setup Utility is disabled.
On LAN 2 in BIOS Setup Utility is disabled.
Three short beeps, pause, three more short beeps, and
one short beep.
one short beep.
One short beep, pause, three short beeps, pause, three
more short beeps, and one short beep.
more short beeps, and one short beep.
1. DIMM.
2. System board
2. System board
Only the cursor appears.
Reinstall the operating system.
Four cycles of four short beeps and a blank screen.
System board (security chip)
Five short beeps and a blank screen.
System board
No-beep symptoms
Table 5. No-beep symptoms
Symptom or error
FRU or action, in sequence
No beep, power-on indicator on, LCD blank, and no
POST.
POST.
1. Make sure that every connector is connected
tightly and correctly.
2. DIMM.
3. System board.
3. System board.
No beep, power-on indicator on, and LCD blank during
POST.
POST.
1. Reseat DIMM.
2. System board.
The power-on password prompt appears.
A power-on password or a supervisor password is set.
Type the password and press Enter.
Type the password and press Enter.
The hard-disk password prompt appears.
A hard-disk password is set. Type the password and
press Enter.
press Enter.
LCD-related symptoms
Important: The TFT LCD for the notebook computer contains many thin-film transistors (TFTs). The
presence of a small number of dots that are missing, discolored, or always lighted is characteristic of TFT
LCD technology, but excessive pixel problems can cause viewing concerns.If the LCD you are servicing has
two or less visible defective pixels, it should not be considered faulty. However, if the LCD has three or more
visible defective pixels, it will be deemed as defective by Lenovo and it should be replaced.
presence of a small number of dots that are missing, discolored, or always lighted is characteristic of TFT
LCD technology, but excessive pixel problems can cause viewing concerns.If the LCD you are servicing has
two or less visible defective pixels, it should not be considered faulty. However, if the LCD has three or more
visible defective pixels, it will be deemed as defective by Lenovo and it should be replaced.
Notes:
• This policy applies to all ThinkPad Notebooks purchased on 1 January, 2008 or later.
• Lenovo will not provide replacement if the LCD is within specification as we cannot guarantee that
any replacement LCD will have zero pixel defects.
any replacement LCD will have zero pixel defects.
Chapter 4
.
Related service information
57