HP (Hewlett-Packard) 100BASE-TX User Manual
Chapter 6
59
Troubleshooting 10/100Base-TX/9000
Performance Troubleshooting
a TransmitThreshold of 1500 is conservative
In all of the cases above after setting the Transmit Threshold mode as
specified, the lanadmin command will echo the current speed of the
interface as follows; this output may be ignored (output shown for 100
Mbits/s operation):
specified, the lanadmin command will echo the current speed of the
interface as follows; this output may be ignored (output shown for 100
Mbits/s operation):
old speed= 100000000
new speed= 100000000
After issuing the
lanadmin -S
you must wait at least 5 seconds before
attempting to use the specified network interface.
If the desired Transmit Threshold setting needs to be effective in all
subsequent reboots, you must create an SD script and include it in the
/sbin/init.d directory so that it gets executed on each reboot.
subsequent reboots, you must create an SD script and include it in the
/sbin/init.d directory so that it gets executed on each reboot.