APC Command Line Interface User Manual

uploadini

Upload an INI file, using 

XMODEM, when you are accessing the CLI 
through a serial connection. After the upload 
completes:

• If there are any system or network changes, the 

user interface of the Switched Rack PDU 
restarts, and you must log into the CLI again.

• If you selected a baud rate for the file transfer 

that is not the same as the default baud rate for 
the Switched Rack PDU, you must reset the 
baud rate to the default to reestablish  
communication with the PDU.

Administrator and device manager 

(device-only user).

None.

In the following output format, user input is in 
bold, and additional instructions, which are not 
displayed on the screen, are in italic.

OK
-------------------------------------------------------------
Perform file transfer via XMODEM-CRC?
Enter 'YES' to continue or <ENTER> to cancel: 

 

------- File Transfer Baud Rate-----------------------
               1- 2400
               2- 9600
               3- 19200
               4- 38400
> 

 

Change baud rate to 9600 and press <ENTER>...

 now. 

In the terminal program (such as HyperTerminal) 
browse to and select the .ini file to transfer and, if 
requested, select XMODEM as the transfer 
protocol.  The following output is displayed:
Start XMODEM-CRC Transfer Now!
CCC
-------------------------------------------------------------
1536 bytes have successfully been transmitted.

E101