Thecus Technology 1U4500R User Manual

 

 
 

63 

RAID 1 mirrors all data from one hard disk drive to a second one hard disk drive, 
thus providing complete data redundancy. However, the cost of data storage 

capacity is doubled.  
 

This is excellent for complete data security. 

RAID 5 offers data security and good performance. It is best suited for networks 

that perform many small I/O transactions at the same time, as well as 
applications that require data security such as office automation and online 

customer service. Use it also for applications with high read requests but low 
write requests. 
 

RAID 5 includes disk striping at the byte level and parity information is written to 
several hard disk drives. If a hard disk fails the system uses parity stored on each 

of the other hard disks to recreate all missing information. 

RAID 6 is essentially an extension of RAID level 5 which allows for additional fault 

tolerance by using a second independent distributed parity scheme (dual parity) 
Data is striped on a block level across a set of drives, just like in RAID 5, and a 

second set of parity is calculated and written across all the drives; RAID 6 
provides for an extremely high data fault tolerance and can sustain two 

simultaneous drive failures. 
 
This is a perfect solution for mission critical applications. 

RAID 10 is implemented as a striped array whose segments are RAID 1 arrays. 
RAID 10 has the same fault tolerance as RAID level 1. 

RAID 10 has the same overhead for fault-tolerance as mirroring alone. High I/O 
rates are achieved by striping RAID 1 segments. 

Under certain circumstances, RAID 10 array can sustain multiple simultaneous 
drive failures 

 
Excellent solution for applications that would have otherwise gone with RAID 1 
but need an additional performance boost. 

Although a concatenation of disks (also called JBOD, or "Just a Bunch of Disks") is 
not one of the numbered RAID levels, it is a popular method for combining 

multiple physical disk drives into a single virtual one. As the name implies, disks 
are merely concatenated together, end to beginning, so they appear to be a 

single large disk. 
 

As the data on JBOD is not protected, one drive failure could result total data loss. 
 

The length of the data segments being written across multiple hard disks. Data is 

written in stripes across the multiple hard disks of a RAID. Since multiple disks 
are accessed at the same time, disk striping enhances performance. The stripes 
can vary in size.