Trendnet TVP-224HR User Manual

PC Configuration 

From your Macintosh, you can access the Internet via the TVP-224HR. The procedure is as 
follows. 
1.  Open the TCP/IP Control Panel.  
2.  Select Ethernet from the Connect via pop-up menu. 
3.  Select Using DHCP Server from the Configure pop-up menu. The DHCP Client ID field 

can be left blank. 

4.  Close the TCP/IP panel, saving your settings. 

If using manually assigned IP addresses instead of DHCP, the required changes are: 
•  Set the Router Address field to the TVP-224HR 's IP Address. 
•  Ensure your DNS settings are correct. 

To access the Internet via the TVP-224HR, it is only necessary to set the TVP-224HR as the 
"Gateway". 
Ensure you are logged in as "root" before attempting any changes. 

By default, most Unix installations use a fixed IP Address. If you wish to continue using a 
fixed IP Address, make the following changes to your configuration. 
•  Set your "Default Gateway" to the IP Address of the TVP-224HR. 
•  Ensure your DNS (Name server) settings are correct. 

The procedure below may vary according to your version of Linux and X -windows shell. 
1.  Start your X Windows client. 
2.  Select Control Panel - Network 
3.  Select the "Interface" entry for your Network card. Normally, this will be called "eth0". 
4.  Click the Edit button, set the "protocol" to "DHCP", and save this data.  
5.  To apply your changes 

•  Use the "Deactivate" and "Activate" buttons, if available. 
•  OR, restart your system. 

To access the Internet via the TVP-224HR: 

•  Ensure the "Gateway" field for your network card is set to the IP Address of the TVP-

224HR. 

•  Ensure your DNS (Name Server) settings are correct. 

37