Trendnet TVP-224HR User Manual
Microsoft VPN
PPPoE Configuration
If using PPPoE (PPP over Ethernet), a screen like the following example will be displayed
when the "PPPoE" button is clicked.
when the "PPPoE" button is clicked.
Figure 20: PPPoE Configuration Screen
Data - PPPoE Screen
Connection
Enable PPPoE
Yes / No
User Name
User Name as assigned by your ISP
Password
Password as assigned by your ISP
Idle timeout in
seconds
seconds
An Internet connection is automatically made when required, and
disconnected when idle for the time period specified by the
"Auto-disconnect Idle Time-out".
disconnected when idle for the time period specified by the
"Auto-disconnect Idle Time-out".
IPCP fixed IP address Default Value: 0.0.0 (Value should only be changed if advised to
do so by Technical Support.)
Authentication
Protocol
Protocol
Default Value: pap(Value should only be changed if advised to
do so by Technical Support.)
do so by Technical Support.)
Transmit Bandwidth
Default Value: 0(Value should only be changed if advised to do
so by Technical Support.)
so by Technical Support.)
MTU Size
MTU (Maximum Transmission Unit) value should only be
changed if advised to do so by Technical Support.
Enter a value between 1 and 1500.
This device will still auto-negotiate with the remote server, to set
changed if advised to do so by Technical Support.
Enter a value between 1 and 1500.
This device will still auto-negotiate with the remote server, to set
the MTU size. The smaller of the 2 values (auto-negotiated,
or entered here) will be used.
or entered here) will be used.
For direct connections (not PPPoE or PPTP), the MTU used is
always 1500.
Buttons
OK
After entering data, click on OK to save settings. You will also
have to reboot the device to make the settings take effect
have to reboot the device to make the settings take effect
43