Net2Phone Max 430 User Manual
Max 410/420/430 User’s Guide – Chapter 3
19
Connecting to the Max 410 through a Serial
Cable
Cable
This section explains how to connect to the Max and
obtain its DHCP IP address. The remaining configuration
tasks can then be completed more easily via the Max Web
Manager.
obtain its DHCP IP address. The remaining configuration
tasks can then be completed more easily via the Max Web
Manager.
NOTE: For the Max 410 units, LAN settings
can only be configured using this method.
can only be configured using this method.
Using the HyperTerminal Emulation Program
For this procedure you will need a standard serial cable
(D-sub 9-pin, male-to-female, straight-through connection)
as shown in Figure 5, and a PC running the
HyperTerminal terminal-emulator program (or an
equivalent), which is included with Microsoft operating
systems. It is usually found in the Programs menu, under
Accessories.
(D-sub 9-pin, male-to-female, straight-through connection)
as shown in Figure 5, and a PC running the
HyperTerminal terminal-emulator program (or an
equivalent), which is included with Microsoft operating
systems. It is usually found in the Programs menu, under
Accessories.
Figure 5 – Serial Cable Connection
1. With the power to the Max 410 turned OFF,
connect the cable from the unit’s serial port to
one of the PC’s serial ports. Note which of the
PC’s serial ports you are using.
one of the PC’s serial ports. Note which of the
PC’s serial ports you are using.
2. Launch HyperTerminal and set up a new
connection.
3. In the dialog box, specify the appropriate serial
port, and set the serial communication
parameters as follows:
parameters as follows:
Baud rate
19200
Parity
None
Character size
8
Stop Bit
1
Flow Control
None