Net2Phone Max 430 User Manual
Max 410/420/430 User’s Guide – Chapter 3
22
addresses, using either a telephone keypad or serial
connection. The process will entail the following steps:
connection. The process will entail the following steps:
1. Disable DHCP in the Max 410/420/430.
2. Enter a static IP address.
3. Enter a netmask address.
4. Reset the unit.
5. Log in to the Max Web Manager.
6. Set the required configuration parameters in the
Max Web Manager.
Entering Static IP Addresses from a
Telephone Keypad
Telephone Keypad
If your LAN uses static IP addresses, the most practical
way to set up the Max 420 or 430 is to enter an IP address
and netmask from a telephone keypad. You can then
finish setting up the unit while browsing the Max Web
Manager.
way to set up the Max 420 or 430 is to enter an IP address
and netmask from a telephone keypad. You can then
finish setting up the unit while browsing the Max Web
Manager.
Disabling DHCP from a telephone keypad (Max
420/430)
420/430)
Since the Max 410/420/430 is shipped with DHCP
enabled, you need to disable DHCP to use static IP
addresses. To disable DHCP, proceed as follows:
enabled, you need to disable DHCP to use static IP
addresses. To disable DHCP, proceed as follows:
1. Connect an analog telephone to any RJ-11 port
on the Max 410/420/430.
2. Lift the handset and dial
***
5 (the disable DHCP
parameter code).
The voice prompt announces, “DHCP is disabled
now. Please press pound”.
The voice prompt announces, “DHCP is disabled
now. Please press pound”.
3. Press the pound key (
#
).
4. Hang up the telephone.
DHCP is now disabled.