Emulex 4 Gb FC Host Bus User Manual

Safety Agency Compliance 
Statements

Read this section before beginning any procedure. The 
following text provides safety precautions to follow when 
installing a Sun Microsystems product.

Safety Precautions

For your protection, observe the following safety 
precautions when setting up your equipment:

■

Follow all cautions and instructions marked on the 
equipment.

■

Ensure that the voltage and frequency of your power 
source match the voltage and frequency inscribed on 
the equipment’s electrical rating label.

■

Never push objects of any kind through openings in 
the equipment. Dangerous voltages may be present. 
Conductive foreign objects could produce a short 
circuit that could cause fire, electric shock, or damage 
to your equipment.

Symbols

The following symbols may appear in this book:

There is a risk of personal injury 

and equipment damage. Follow the 
instructions.

Hot surface. Avoid contact. 

Surfaces are hot and may cause personal 
injury if touched.

Hazardous voltages are present. To 

reduce the risk of electric shock and danger to 
personal health, follow the instructions.

Depending on the type of power switch your device has, 
one of the following symbols may be used:

Applies AC power to the system.

Removes AC power from the system.

The On/Standby switch is in the 

standby position.

Modifications to Equipment

Do not make mechanical or electrical modifications to the 
equipment. Sun Microsystems is not responsible for 
regulatory compliance of a modified Sun product.

Placement of a Sun Product

Do not block or cover the openings 

of your Sun product. Never place a Sun 
product near a radiator or heat register. 
Failure to follow these guidelines can cause 
overheating and affect the reliability of your 
Sun product.

Noise Level

In compliance with the requirements defined in DIN 45635 
Part 1000, the workplace-dependent noise level of this 
product is less than 70 db(A).