Wayne-Dalton WDSF-10 User Manual

11

1.  To draw a room, click the DRAW 

RooMS button in the Design pane.  

This will enable DRAW RooMS 

mode.  To exit this mode, click the 

DRAW RooMS button again.

once in this mode, you may draw 

one or more rooms.  

To draw a room:

•  Move your mouse pointer to the 

location in the open center area of 

the software interface where you 

would like to draw your room.  This 

will be one corner of the room.

•  Press the left button on your 

mouse and then move your mouse 

diagonally to where the opposite 

corner of the room should be.

•  To complete the room, release 

the left mouse button.  

•  When prompted, type a name 

for the room.

To draw a non-rectangular room:

•  Draw the largest rectangular 

section of the room per the above 

instructions.

•  To draw an additional segment 

of the room, press the left mouse 

button inside the room and then 

move your mouse diagonally to an 

empty area outside of the room.

•  To complete the extension to 

the room, release the left mouse 

button.

•  To erase unwanted sections 

of the room, use the eRASe mode 

(See next section).

Continued next page...

example of Floor Layout.

Click on DRAW RooMS to enter 
or leave drawing mode.

