Wayne-Dalton WDSF-10 User Manual

8

1.  From the Design tab, press the 

ADD DeVICe button.  A message 

window will ask you to press the 

button on the device to add.
2.  Press-and-release the 

PRoGRAM button on the Z-Wave

®

 

module.  If successful, a message 

window will appear stating that 

the device has been successfully 

added.  Repeat this procedure if a 

message window states that the 

module failed to be included.
NoTe:  For your security, the USB 

Z-Wave

®

 Adapter must be within 

3 feet of the Z-Wave

®

 module to 

be added.  If this is not possible, 

please set up your network with 

a portable remote controller and 

then copy this information to 

the USB adapter (See “Joining 

Thinkessentials

®

 to existing 

Networks”, page 22).
NoTe:  Please see the User 

Manual or Instruction Manual for 

the specific Z-Wave

®

 module 

being programmed to locate the 

PRoGRAM button and for specific 

programming information.  To add 

a new controller as a secondary 

controller to the network, please 

see the section “Adding a Controller 

to the Network” page 24.
TIP:  If the Z-Wave

®

 module fails 

to be included in the network it 

may have previously been used in 

another network and needs to be 

reset.  Press the ReMoVe DeVICe 

button in Thinkessentials

®

 and then 

press and release the PRoGRAM 

button on the Z-Wave

®

 module.

NoTe:  The process of adding 

modules to a network is often 

referred to as INCLUSIoN.

Continued next page...



Press ADD DeVICe to add a Z-Wave

®

 module. 

 

      

ON/

OFF

 

   

  

 P

R

OG.

/DI

M

Press-and-Release 
PRoGRAM button on 
module

Device added successfully message window.

