Adder Technology AV Series User Manual

To connect the link cable(s)
The links between the transmitter and receiver modules are made using between 
one and four twisted pair cables, specified to Category 5 or higher. Each cable 
carries video and audio signals to each receiver module.
When a single receiver is attached to a link cable, the maximum length of that 
link cable is 300m (1000 feet). 

1  Attach the connector of the first link cable to the socket 

labelled 

 on the AdderLink AV104 transmitter. 

There should be a click when the cable is fully 
inserted and locked in place.

2  Attach the connectors of the 

remaining link cables to the 
sockets labelled 

 to 

, as required.

   In all cases, there should be 

a click when the cable is fully 
inserted and locked in place.

RECEIVER

TRANSMITTER

Overall maximum link length: 300m

STANDARD LINK

However, if further receivers are connected in cascade to the initial receiver using 
its 

 port (AdderLink AV101 models only), then the overall length of the 

link cables used must be reduced. For further information, please refer to the 
section 

NOTE: Where possible, avoid laying the twisted pair link cable(s) alongside 
power cables. 

1  Attach the connector of the link cable to the socket labelled 

 on the AdderLink AV100/AV200 transmitter. There 

should be a click when the cable is fully inserted 
and locked in place.

receivers must not be connected, 
via a CATx link, to AV100, 
AV101 or AV104 modules. 
Cascade connections to 
other transmitter types are 
possible, however, using the 
video and audio out ports. 
For further information, please 
refer to the section