Lucent Technologies 9077 16S User Manual
Monitoring and Management Tools
SP Switch Router command overview
SP Switch Router Adapter Guide - 1.4 Update 2
October 22, 1999
3-3
getver
This command tells you the version of the operating system that is currently running. It can
also report which release version will be run the next time the system is booted. In this case,
getver is used in conjunction with setver. The setver command specifies which release will be
run at the next system boot.
also report which release version will be run the next time the system is booted. In this case,
getver is used in conjunction with setver. The setver command specifies which release will be
run at the next system boot.
grarp
The grarp command displays the ARP table for a given IP address. If you specify grarp with
the IP address of the SP Switch Router Adapter card, it returns a physical address that is the
switch node number to which this card connects.
the IP address of the SP Switch Router Adapter card, it returns a physical address that is the
switch node number to which this card connects.
# grarp 192.146.162.67
gt030 (0): 192.146.162.67 at 0:0:0:0:0:2
In this example, 192.146.162.67 is the IP address of the SP Switch Router Adapter card in
slot 3 (interface name
slot 3 (interface name
gt030)
, and 0:0:0:0:0:2 is the switch node number. Other grarp options
edit, add, or remove ARP table entries.
grcard
This command displays slot number, media type, and current operating status of the installed
media cards.
media cards.
super> grcard
0 FDDI_V2 running
1 FDDI_V2 running
2 ETHER_V1 running
3 HSSI_V1 running
5 HSSI_V1 running
6 SONET_V1 running
7 ETHER_V1 running
8 FDDI_V2 running
9 ATM_OC3_V2 running
10 HIPPI_V1 running
11 HSSI_V1 running
12 DEV1_V1 running
13 DEV1_V1 running
14 ATM_OC12_V2 running
15 ATM_OC12_V2 running
grfins
This command installs a release onto the internal flash device. In the process, it installs all the
new files and converts the system configuration files as required. Rebooting moves the image
to RAM.
new files and converts the system configuration files as required. Rebooting moves the image
to RAM.
As an example, if a release has a new
/etc/gratm.conf
file, grfins does not write over your
current version. Instead, it installs a new version of the
/etc/gratm.conf.template
file. In
this way, you can copy the current configuration information into the new
.template
file,
make any changes, and then save that file as the new
/etc/gratm.conf
.