Lucent Technologies 6000 User Manual
Configuring WAN Access
Configuring inbound calls
MAX 6000/3000 Network Configuration Guide
3-61
Ans 2#=1237
Ans 3#=1238
Ans 4#=1239
Note:
When a MAX unit has more than one digital modem slot card installed, the cards and
modems form a pool, and any modem can answer a call routed to any digital modem slot.
Specifying host ports’ slot and port numbers in WAN channel
configurations
configurations
A MAX unit checks for slot and port number specifications. If a slot is specified for the
channel on which the call arrives, it uses it to route the call. (If the unit also finds a port
number, it routes to that specific port on the slot number.) If not, the unit goes on to the next
comparison.
channel on which the call arrives, it uses it to route the call. (If the unit also finds a port
number, it routes to that specific port on the slot number.) If not, the unit goes on to the next
comparison.
In the configuration of WAN lines, you can assign one or more channels to a slot card. In the
case of an AIM slot card, you can assign channels to a port on the card. This channel
configuration affects both inbound call routing and the placement of calls. In effect, the
configuration reserves the channel for calls to and from the specified slot or port.
case of an AIM slot card, you can assign channels to a port on the card. This channel
configuration affects both inbound call routing and the placement of calls. In effect, the
configuration reserves the channel for calls to and from the specified slot or port.
Configure slot and port routing only when answer number and ISDN subaddress routing are
not specified. Following are the related parameters (shown with sample settings):
not specified. Following are the related parameters (shown with sample settings):
Net/T1
Line Config
Line Config profile
Line N...
Ch N=Switched
Ch N Slot=3
Ch N Prt/Grp=1
Net/E1
Line Config
Line Config profile
Line N...
Ch N=Switched
Ch N Slot=3
Ch N Prt/Grp=1
Net/BRI
Line Config
Line Config profile
Line N...
BN Usage=Switched
BN Slot=3
BN Prt/Grp=1
When a MAX unit receives an inbound call and no subaddress is in use or no matching answer
number is found, it evaluates the slot and port specifications and routes the call to the specified
destination. For example, for the MAX 6000 shown in Figure 3-1 on page 3-2:
number is found, it evaluates the slot and port specifications and routes the call to the specified
destination. For example, for the MAX 6000 shown in Figure 3-1 on page 3-2:
•
0 (zero, the default) specifies that the Ch N Slot parameter is not used to route incoming
calls.
calls.
•
1 and 2 are invalid settings, because they represent the built-in slots for T1 or E1 lines.