Lucent Technologies 6000 User Manual
MAX 6000/3000 Network Configuration Guide
xxix
About This Guide
How to use this guide
This guide explains how to configure and use the MAX
TM
as an Internet Service Provider
(ISP) or telecommuting hub. Chapter 1, “Introduction,” begins with a condensed table of con-
tents, followed by an overview of the manual’s contents. Each subsequent chapter begins with
a chapter table of contents, followed by a brief overview of the chapter’s contents. Read the
overview sections if you are not sure about which information applies to your installation.
tents, followed by an overview of the manual’s contents. Each subsequent chapter begins with
a chapter table of contents, followed by a brief overview of the chapter’s contents. Read the
overview sections if you are not sure about which information applies to your installation.
Note:
This guide describes the full set of features for MAX 6000 and MAX 3000 units.
Some
features might not be available with
earlier versions or specialty loads of the software.
Warning:
Before installing this product, see the Important Safety Instructions in the
Installation and Basic Configuration Guide for your MAX unit.
What you should know
This guide is for the person who configures and maintains the MAX. To configure the MAX,
you need to understand the following:
you need to understand the following:
•
Wide Area Network (WAN) concepts
•
Local Area Network (LAN) concepts, if applicable
Documentation conventions
Following are all the special characters and typographical conventions used in this manual:
Convention
Meaning
Monospace text
Represents text that appears on your computer’s screen, or that could
appear on your computer’s screen.
appear on your computer’s screen.
Boldface mono-
space text
Represents characters that you enter exactly as shown (unless the char-
acters are also in italics—see Italics, below). If you could enter
the characters but are not specifically instructed to, they do not appear
in boldface.
acters are also in italics—see Italics, below). If you could enter
the characters but are not specifically instructed to, they do not appear
in boldface.
Italics
Represent variable information. Do not enter the words themselves in
the command. Enter the information they represent. In ordinary text,
italics are used for titles of publications, for some terms that would
otherwise be in quotation marks, and to show emphasis.
the command. Enter the information they represent. In ordinary text,
italics are used for titles of publications, for some terms that would
otherwise be in quotation marks, and to show emphasis.