Lucent Technologies 6000 User Manual
11-36
MAX 6000/3000 Network Configuration Guide
Setting Up Virtual Private Networks
Configuring L2TP tunnels for dial-in clients
Configuring L2TP tunnels for dial-in clients
Ascend-Disconnect-Cause = 185
Ascend-Connect-Progress = 60
Ascend-Xmit-Rate = 28800
Ascend-Data-Rate = 33600
Ascend-PreSession-Time = 19
Ascend-Pre-Input-Octets = 0
Ascend-Pre-Output-Octets = 0
Ascend-Pre-Input-Packets = 0
Ascend-Pre-Output-Packets = 0
Ascend-Modem-PortNo = 1
Ascend-Modem-SlotNo = 7
Ascend-Modem-ShelfNo = 1
Caller-Id = "1119855510"
Client-Port-DNIS = "3826"
Tunnel-Type = L2TP
Tunnel-Server-Endpoint = "1.1.1.1"
Tunnel-Client-Auth-ID = "taos-unit"
Tunnel-Server-Auth-ID = "max6k-lns"
Tunnel-Assignment-ID = "modem-taid"
Configuration of the MAX as an LAC
An LAC is responsible for requesting L2TP tunnels to the LNS. You configure the LAC to
determine when a dial-in connection should be tunneled, and you can specify the LNS used for
the connection.
determine when a dial-in connection should be tunneled, and you can specify the LNS used for
the connection.
Understanding the L2TP LAC parameters
This section provides some background information about parameters used in configuring the
MAX as an LAC:
MAX as an LAC:
Parameter
How it’s used
L2TP Mode
Enables the MAX unit’s LAC functionality if you set L2TP Mode to
LAC or Both.
LAC or Both.
L2TP Auth
Enabled
Enabled
You must either enable tunnel authentication for both the LAC and LNS
or enable it for neither. You configure a tunnel password in a
Names/Passwords profile.
or enable it for neither. You configure a tunnel password in a
Names/Passwords profile.
L2TP RX Window Specifies the number of unacknowledged packets the MAX receives
(when configured as an LAC or a LNS) before requesting that the
sending device stop transmitting data.
sending device stop transmitting data.
Line N Tunnel
Type
Type
Specifies whether the MAX should dedicate an entire WAN line to either
L2TP or PPTP. If you want the MAX to establish tunnels on a
connection-by-connection basis, set Line N Tunnel Type to None on all
lines.
L2TP or PPTP. If you want the MAX to establish tunnels on a
connection-by-connection basis, set Line N Tunnel Type to None on all
lines.
Route Line N
Specifies the IP address of the LNS. This parameter applies only if you
dedicate an entire WAN line to tunneling with the Line N Tunnel Type
parameter. If you want the MAX to establish tunnels on a
connection-by-connection basis, leave Route Line N blank for all lines.
dedicate an entire WAN line to tunneling with the Line N Tunnel Type
parameter. If you want the MAX to establish tunnels on a
connection-by-connection basis, leave Route Line N blank for all lines.