Lucent Technologies 6000 User Manual
Configuring WAN Access
Configuring ISDN BRI network cards
MAX 6000/3000 Network Configuration Guide
3-37
BRI channels in the same trunk group. For details, see “Configuring outbound calls” on
page 3-69.
page 3-69.
Configuring add-on numbers and SPIDs
The Pri Num and Sec Num parameters define additional telephone numbers for multichannel
calls, and SPIDs identify services provisioned for your ISDN line. For more details about
add-on numbers and SPIDs, see “Assigning telephone numbers” on page 3-5.
calls, and SPIDs identify services provisioned for your ISDN line. For more details about
add-on numbers and SPIDs, see “Assigning telephone numbers” on page 3-5.
To configure add-on numbers and SPIDs for your ISDN BRI line, open a Net/BRI > Line
Config > Line Config profile, then open the line’s Line N subprofile and set the following
parameters:
Config > Line Config profile, then open the line’s Line N subprofile and set the following
parameters:
For detailed information about each parameter, see the MAX Reference. For more information
about SPIDs, see “SPIDS (for Net/BRI lines)” on page 3-6.
about SPIDs, see “SPIDS (for Net/BRI lines)” on page 3-6.
Note:
After you have configured the line, you might need to configure the card for outbound
calls (as described in “Configuring the Net/BRI line for outbound calls” on page 3-38).
Typical Net/BRI configurations, with examples
Typical Net/BRI line configurations for MAX units include configurations for incoming
switched connections and for outbound calls.
switched connections and for outbound calls.
Configuring incoming switched connections
The following procedure assumes that the MAX BRI lines connect to a NI-1 switch running in
multipoint mode:
multipoint mode:
1
Open a Net/BRI > Line Config profile.
2
Set the Name parameter to assign a name to the profile.
3
Set the Switch Type parameter to specify the carrier switch type.
4
Set the BRI Analog Encode parameter to specify analog encoding for modem calls.
5
Open the Line 1 subprofile, and set Enable to Yes to enable the line.
6
Set the Link Type parameter to specify multipoint mode.
7
Configure the B channels for switched usage and for routing to the local network.
8
Specify the primary and secondary add-on numbers and their associated SPIDs.
Parameter
Specifies
Pri Num
Primary add-on number for the ISDN BRI line. If you configure the line
for point-to-point service, this is the only number associated with the line.
for point-to-point service, this is the only number associated with the line.
Pri SPID
Primary Service Profile Identifier (SPID) for ISDN BRI line.
Sec Num
Secondary add-on number for the ISDN BRI line. If you configure the
line for point-to-point service, Sec Num is not applicable.
line for point-to-point service, Sec Num is not applicable.
Sec SPID
SPID (Service Profile Identifier) associated with the secondary telephone
number for the ISDN BRI line.
number for the ISDN BRI line.