Enterasys Networks 1H582-xx User Manual
General Configuration Command Set
Configuring Enterasys and Cisco Discovery Protocols
3-68
3.2.6
Configuring Enterasys and Cisco Discovery Protocols
Purpose
To enable and configure the Enterasys (CDP) and Cisco discovery protocols. These protocols are
used to discover network topology. When enabled, they allow Enterasys and Cisco devices to send
periodic PDUs about themselves to neighboring devices. The Cisco Discovery Protocol is also used
to manage the Cisco module of the Convergence End Points (CEP) IP phone detection function
described in
used to discover network topology. When enabled, they allow Enterasys and Cisco devices to send
periodic PDUs about themselves to neighboring devices. The Cisco Discovery Protocol is also used
to manage the Cisco module of the Convergence End Points (CEP) IP phone detection function
described in
Commands
The commands needed to configure the Enterasys and Cisco discovery protocols are listed below
and described in the associated section as shown.
and described in the associated section as shown.
•
show cdp (
•
)
•
set cdp interval (
)
•
show ciscodp (
)
•
•
)
•
set ciscodp holdtime (
)
•
set ciscodp populatecdp (
•
•
show port ciscodp neighborinfo (
)
•
•
set port ciscodp trust-ext (
)
•
set port ciscodp cos-ext (
•