Enterasys Networks 1H582-xx User Manual
SNMP Command Set
Configuring SNMP Target Parameters
5-40
Syntax Description
Command Defaults
If not specified, storage type will be set to nonvolatile.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set SNMP target parameters named “v1ExampleParams” for a user
named “fred” using version 3 security model and message processing, and authentication:
named “fred” using version 3 security model and message processing, and authentication:
paramsname
Specifies a name identifying parameters used to generate
SNMP messages to a particular target.
SNMP messages to a particular target.
user user
Specifies an SNMPv1 or v2 community name or an
SNMPv3 user name. Maximum length is 32 bytes.
SNMPv3 user name. Maximum length is 32 bytes.
security-model v1 |
v2 | v3
v2 | v3
Specifies the SNMP security model applied to this target
parameter as version 1, 2c or 3.
parameter as version 1, 2c or 3.
noauthentication |
authentication |
privacy
authentication |
privacy
Specifies the SNMP security level applied to this target
parameter as no authentication, authentication (without
privacy) or privacy. Privacy specifies that messages sent
on behalf of the user are protected from disclosure.
parameter as no authentication, authentication (without
privacy) or privacy. Privacy specifies that messages sent
on behalf of the user are protected from disclosure.
volatile |
nonvolatile
nonvolatile
(Optional) Specifies the storage type applied to this target
parameter.
parameter.
Matrix>set snmp targetparams v1ExampleParams user fred security-model v3
authentication