Enterasys Networks 1H582-xx User Manual
Port Priority and Classification Configuration Commands
Configuring Port Traffic Rate Limiting
9-36
9.3.6.2
set port ratelimit
Use this command to configure the traffic rate limiting status and threshold (in bits per second) for
one or more ports.
one or more ports.
set port ratelimit {disable | enable port-string priority threshold {discard |
marked}{disable | enable}}
marked}{disable | enable}}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
disable | enable
Disables or enables rate limiting globally on the device.
port-string
Specifies port(s) on which to set the rate limiting
threshold and other parameters. For a detailed
description of possible port-string values, refer to
threshold and other parameters. For a detailed
description of possible port-string values, refer to
priority
Specifies the 802.1D port priority level associated with
the port-string. Valid values are:
the port-string. Valid values are:
•
0 - 7, with 0 specifying the lowest priority, and
•
all to set the rate limiting threshold and other
parameters on all port priority levels associated with
the port-string.
parameters on all port priority levels associated with
the port-string.
threshold
Specifies a port rate limiting threshold in bits per second.
Range is 195000 up to the maximum bits per second rate
for a given interface.
Range is 195000 up to the maximum bits per second rate
for a given interface.
discard | marked
Discards all frames, or discards marked frames when set
rate limit is reached.
rate limit is reached.
disable | enable
Disables or enables the port rate limiting function on
selected ports when the global device rate limiting
function is enabled.
selected ports when the global device rate limiting
function is enabled.