Enterasys Networks 1H582-xx User Manual
Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
11-77
Example
This example shows how to globally enable CEP detection
:
11.2.6.3 set cep port
Use this command to enable or disable a CEP detection type on one or more ports.
set cep port port-string {cisco | h323 | siemens} {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable Cisco phone detection on port fe. 3. 1
:
11.2.6.4 set cep policy
Use this command to set a global default policy for a CEP detection type. This is the policy that will
be applied when a phone of the specified type is detected on a port. It must be configured using the
policy management commands described in
be applied when a phone of the specified type is detected on a port. It must be configured using the
policy management commands described in
.
set cep policy {cisco | h323 | siemens} profile-id
Matrix>set cep enable
port-string
Specifies the port(s) to enable or disable. For a detailed
description of possible port-string values, refer to
description of possible port-string values, refer to
.
cisco | h323 |
siemens
siemens
Specifies the CEP detection that will be applied as Cisco,
H.323 or Siemens phone detection.
H.323 or Siemens phone detection.
enable | disable
Enables or disables CEP detection as specified.
Matrix>set cep port fe.3.1 cisco enable