Enterasys Networks 1H582-xx User Manual
Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
11-81
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set an IP address of 10.1.1.3 for detection group 1:
11.2.6.8 set cep detection protocol
Use this command to specify an IP protocol type for H.323 or Siemens convergence end points
detection. If an IP address is not set for a phone detection group as described in
detection. If an IP address is not set for a phone detection group as described in
,
this will configure detection on UDP and/or TCP ports using a port range defined with the set cep
detection porthigh | portlow command as described in
detection porthigh | portlow command as described in
.
set cep detection detection-id protocol {tcp | udp | both | none}
detection-id
Specifies a CEP discovery group ID. This group must be
created and enabled using the set cep detection command
as described in
created and enabled using the set cep detection command
as described in
. Valid values are 1 -
2147483647.
address
Sets an IP address for the CEP discovery group.
ipv4 ip-address |
unknown
unknown
Specifies an IPv4 address or an address of an unknown IP
protocol type.
protocol type.
mask
Sets an address mask for the CEP discovery group.
ipv4 mask |
unknown
unknown
Specifies an IPv4 address mask or an address mask of an
unknown IP protocol type.
unknown IP protocol type.
Matrix>set cep detection 1 address ipv4 10.1.1.3
NOTE: This command applies only to Siemens and H.323 phone detection. Cisco
detection uses CiscoDP as its discovery method.
detection uses CiscoDP as its discovery method.