Enterasys Networks 1H582-xx User Manual

Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide

This chapter describes the Routing Protocol Configuration set of commands and how to use them.

Use the following steps as a guide to configuring routing protocols on the device: 

1. Configuring RIP (

2. Configuring OSPF (

3. Configuring DVMRP (

4. Configuring IRDP (

)

5. Configuring VRRP (

ROUTER: The commands covered in this chapter can be executed when the device is 
in router mode only. For details on how to enable router configuration modes, refer to 

NOTE: The command prompts used in examples throughout this guide show a system 
where VLAN 1 has been configured for routing. The prompt changes depending on your 
current configuration mode, and the interface types and numbers configured for routing 
on your system.