Epson 80211b User Manual
16
Configuring the Print Server
After the software is installed, you’re ready to establish a connection to the
print server and configure it for your wireless network.
print server and configure it for your wireless network.
1. When you see the Wireless Server Search window, click
START.
WP-Admin picks up the signal from the print server and displays server
information like the following:
information like the following:
If WP-Admin fails to pick up a signal from the print server, try
holding down the print server’s test button for at least five
seconds to reset it. The lights go out, then both the green and
yellow lights come on briefly. The yellow light remains on
when your network has a connection to the print server.
holding down the print server’s test button for at least five
seconds to reset it. The lights go out, then both the green and
yellow lights come on briefly. The yellow light remains on
when your network has a connection to the print server.
If it still fails to pick up a signal, check the solutions beginning
on page 40.
on page 40.
2. If WP-Admin picks up a signal from more than one server, select the
connection that matches the MAC address on the back of your print
server.
server.
3. Check the signal strength to make sure you have a good link to the print
server. If you have a link, click
STOP
. Then click
CONFIGURE
.
Click START
This information
appears when the
server is found
appears when the
server is found
This number
indicates the
signal strength
indicates the
signal strength
ZLUHOHVVVHUYHUERRN3DJH)ULGD\0D\30