Enterasys Networks 2G4082-25 User Manual
DFE-Platinum Module
1-2 Introduction
DFE-Platinum Module
This section provides an overview of the 2G4082‐25 DFE module (
). For information
about features of the DFE‐Platinum modules and how to configure them, refer to the Enterasys
Matrix DFE‐Diamond/Platinum Series Configuration Guide.
Matrix DFE‐Diamond/Platinum Series Configuration Guide.
2G4082-25
The 2G4082‐25 module has 24, 10BASE‐T/100BASE‐TX/1000BASE‐T compliant ports by means of
24 fixed front‐panel RJ45 connectors and a slot for an optional network expansion module (NEM).
24 fixed front‐panel RJ45 connectors and a slot for an optional network expansion module (NEM).
Each of the fixed front panel ports can operate in either half‐duplex or full‐duplex mode of
operation. The duplex mode can be determined by either auto‐negotiation or manual
configuration.
operation. The duplex mode can be determined by either auto‐negotiation or manual
configuration.
The DFE module ports can be configured to control traffic by limiting the rate of traffic accepted
into the module and prioritizing traffic to expedite the flow of higher priority traffic through the
module.
into the module and prioritizing traffic to expedite the flow of higher priority traffic through the
module.
The DFE module receives power and backplane connectivity when it is inserted into a chassis.
Note: The DFE-Platinum 2G4082-25 module can be installed in the single-slot of the Matrix N1
chassis, or in any slot of the Matrix E7, Matrix N7, Matrix N5, or Matrix N3, but does not have FTM
connectivity.
chassis, or in any slot of the Matrix E7, Matrix N7, Matrix N5, or Matrix N3, but does not have FTM
connectivity.
When installed in the Matrix E7, Matrix N7, Matrix N5, or Matrix N3, the 2G4082-25 will boot as a
standalone device with no connectivity to other modules in the chassis.
standalone device with no connectivity to other modules in the chassis.