Hypercom 1202 Leaflet
Mounting Template
Two #8 wood screws are required to mount the unit either vertically or
horizontally. Use this page as a template for determining screw locations.
horizontally. Use this page as a template for determining screw locations.
Leave 1/2 inch (1.3 cm) of the screw head exposed; you can then slide the base
of the unit directly onto the screw heads for mounting.
of the unit directly onto the screw heads for mounting.
Horizontal Mount 4.5 in./11.43 cm
center to center
Vertical Mount 3.0 in./7.62 cm
center to center
This product includes software developed by the University of California, Berkeley and its contributors. This
product includes cryptographic software written by Eric Young (eay@cryptsoft.com).
product includes cryptographic software written by Eric Young (eay@cryptsoft.com).
Copyright 2005 by Hypercom Corporation. All Rights Reserved. Hypercom and the Hypercom logo are registered
trademarks of Hypercom Corporation. IN-tact is a trademark of Hypercom Corporation. 940475-001, Rev B
trademarks of Hypercom Corporation. IN-tact is a trademark of Hypercom Corporation. 940475-001, Rev B
fkJ
í~Åí=
»
NOMO
fåëí~ää~íáçå=dìáÇÉ