IBM WRT-410 User Manual

 

- 26 - 

 

Enable: Click to enable or disable the firewall rule profile. 

Name: Type a descriptive name for the firewall rule profile. 

Action: Select whether to allow or deny packets that conform to the rule. 

Source: Defines the source of the incoming packet that the rule is applied to. 

Interface: Select which interface (WAN or LAN) the rule is applied to. 

IP Range Start: Type the start IP address that the rule is applied to. 

IP Range End: Type the end IP address that the rule is applied to. 

Destination: Defines the destination of the incoming packet that the rule is applied to. 

Interface: Select which interface (WAN or LAN) the rule is applied to. 

IP Range Start: Type the start IP address that the rule is applied to. 

IP Range End: Type the end IP address that the rule is applied to. 

Protocol: Select the protocol (TCP, UDP or ICMP) of the destination. 

Port Range: Select the port range. 

Add: Click to add the rule profile to the table at the bottom of the screen. 

Update: Click to update information for the rule if you have selected a list item and changed. 

Delete: Select a list item and click 

“Delete” to remove the item from the list. 

New: Click 

“New” to erase all fields and enter new information. 

Priority Up: Select a rule from the list and click 

“Priority” Up to increase the priority of the rule. 

Priority Down: Select a rule from the list and click 

“Priority Down” to decrease the priority of the rule. 

Update Priority: After increasing or decreasing the priority of a rule, click 

“Update Priority” to save the 

changes. 

This screen allows you to configure SNMP.