Riverstone Networks WICT1-12 User Manual
Riverstone Networks RS Switch Router User Guide Release 8.0 5-13
Bridging Configuration Guide
Configuring VLANs for Bridging
You can enable the collection of VLAN statistics on 10/100 and Gigabit Ethernet ports configured as 802.1Q trunk
ports. To do so, use the
ports. To do so, use the
port enable per-vlan-stats
command. Then, you can display the statistics by using the
port show per-vlan-stats
command as illustrated in the following example:
5.8
CONFIGURING VLANS FOR BRIDGING
The RS allows you to create VLANs for AppleTalk, DECnet, SNA, and IPv6 traffic as well as for IP and IPX traffic.
You can create a VLAN for handling traffic for a single protocol, such as a DECnet VLAN. Or, you can create a VLAN
that supports several specific protocols, such as SNA and IP traffic.
You can create a VLAN for handling traffic for a single protocol, such as a DECnet VLAN. Or, you can create a VLAN
that supports several specific protocols, such as SNA and IP traffic.
Note
Some commands in this facility require updated RS hardware.
5.9
CONFIGURING LAYER-2 FILTERS
Layer-2 security filters on the RS allow you to configure ports to filter specific MAC addresses. When defining a
Layer-2 security filter, you specify to which ports you want the filter to apply. For details on configuring Layer-2
filters, refer to
Layer-2 security filter, you specify to which ports you want the filter to apply. For details on configuring Layer-2
filters, refer to
•
Address filters
These filters block traffic based on the frame's source MAC address, destination MAC address, or both source and
destination MAC addresses in flow bridging mode. Address filters are always configured and applied to the input
port.
These filters block traffic based on the frame's source MAC address, destination MAC address, or both source and
destination MAC addresses in flow bridging mode. Address filters are always configured and applied to the input
port.
•
Port-to-address lock filters
These filters prohibit a user connected to a locked port or set of ports from using another port.
These filters prohibit a user connected to a locked port or set of ports from using another port.
•
Static entry filters
rs# port show per-vlan-stats port et.10.4
Traffic Statistics for Port et.10.4, VLAN red (VLAN ID 2):
Inbound
Octets: 107,196,271 octets
Frames: 134,940 frames
Outbound
Octets: 105,965,469 octets
Frames: 133,549 frames
Traffic Statistics for Port et.10.4, VLAN blue (VLAN ID 3):
Inbound
Octets: 354,072,575 octets
Frames: 446,763 frames
Outbound
Octets: 347,463,892 octets
Frames: 435,218 frames