Toshiba ETH-100 User Manual
27
11.2 Telnet
The console is also accessible via a Telnet interface for remote administration
over Ethernet once the unit is communicating on the network. The Telnet
console uses well-known port 23. Note that although only 1 telnet console
session can be active at any given time, the telnet console and RS232 console
operate independently and can be used simultaneously.
over Ethernet once the unit is communicating on the network. The Telnet
console uses well-known port 23. Note that although only 1 telnet console
session can be active at any given time, the telnet console and RS232 console
operate independently and can be used simultaneously.
11.2.1 Requirements
All that is needed is a computer with telnet software that can access the ETH-
100 over the Ethernet network. Telnet software is typically included as a
standard component of Microsoft Windows and other PC operating systems.
100 over the Ethernet network. Telnet software is typically included as a
standard component of Microsoft Windows and other PC operating systems.
11.2.2 Connection
No special connections are required, other than the PC running the Telnet
application must be able to access the ETH-100 to be configured.
application must be able to access the ETH-100 to be configured.
11.2.3 Application Configuration
Although any software vendor’s Telnet client application can be used, the
configuration example given here will use the Microsoft Windows Telnet
application. To start the Telnet application, simply type “telnet” at either a DOS
(command) prompt or in the “Start…Run” window. Once the telnet client
screen opens, the target device can be accessed simply by typing “open” at
the Telnet prompt with the ETH-100’s IP address as an argument. Refer to
Figure 12.
configuration example given here will use the Microsoft Windows Telnet
application. To start the Telnet application, simply type “telnet” at either a DOS
(command) prompt or in the “Start…Run” window. Once the telnet client
screen opens, the target device can be accessed simply by typing “open” at
the Telnet prompt with the ETH-100’s IP address as an argument. Refer to
Figure 12.
Figure 12: Telnet Menu