TP-LINK TL-WA830RE User Manual
TL-WA830RE
300Mbps Wireless N Range Extender User Guide
Figure 4-26 SNMP Settings
¾
SNMP Agent - Select the radio button before Enable will enable this function if you want to
have remote control through SNMPv1/v2 agent with MIB-II. Select the radio button before
Disable will disable this function. The default setting is Disable.
have remote control through SNMPv1/v2 agent with MIB-II. Select the radio button before
Disable will disable this function. The default setting is Disable.
¾
SysContact - The textual identification of the contact person for this managed node.
¾
SysName - An administratively-assigned name for this managed node.
¾
SysLocation - The physical location of this node.
)
Note:
Specifying one of these values via the Device's Web-Based Utility makes the corresponding object
read-only. If there isn't such a config setting, then the write request will succeed (assuming
suitable access control settings), but the new value would be forgotten the next time the agent was
restarted.
read-only. If there isn't such a config setting, then the write request will succeed (assuming
suitable access control settings), but the new value would be forgotten the next time the agent was
restarted.
¾
Get Community - Enter the community name that allows Read-Only access to the Device's
SNMP information. The community name can be considered a group password. The default
setting is “public”.
SNMP information. The community name can be considered a group password. The default
setting is “public”.
¾
Get Source - Get source defines the IP address or subnet for management systems that can
read information from this 'get' community device.
read information from this 'get' community device.
¾
Set Community - Enter the community name that allows Read/Write access to the Device's
SNMP information. The community name can be considered a group password. The default
setting is “private”.
SNMP information. The community name can be considered a group password. The default
setting is “private”.
¾
Set Source - Set source defines the IP address or subnet for management systems that can
control this 'set' community device.
control this 'set' community device.
)
Note:
A restricted source can be a specific IP address (e.g. 10.10.10.1), or a subnet - represented as
IP/BITS (e.g. 10.10.10.0/24). If an IP Address of 0.0.0.0 is specified, the agent will accept all
requests under the corresponding community name.
IP/BITS (e.g. 10.10.10.0/24). If an IP Address of 0.0.0.0 is specified, the agent will accept all
requests under the corresponding community name.
Click the Save button to save your settings.
4.7.2 Diagnostic
Selecting System Tools > Diagnostic allow you to check the connections of your network
components on the screen shown in Figure 4-27.
components on the screen shown in Figure 4-27.
41