Carrier Access Access Navigator User Manual

Do not locally provision the Access Bank II if you are remotely provisioning it 

through the Access Navigator. Local changes made to the Access Bank II will not be 
recorded in the Access Navigator data base. Consequently, any local changes will be 
overwritten when the Access Navigator downloads configuration settings.

set remote <n> config off

Temporarily disable configuration 
downloading to remote Access Bank 
II.

set ds1 <n> type drop
set ds1 <n> framing esf
set ds1 <n> linecode b8zs
set ds1 <n> remote mgmt cafdl
set ds1 <n> lbo <setting>
set ds1 <n> loopdetect off
set ds1 <n> id <"name">
set remote <n> id <"name">

Provision DS1 service to remote, 
including remote management 
interface.

set ds0 <n:ch> type <setting>
set ds0 <n:ch> signaling <setting>
set ds0 <n:ch> crv <setting>
set ds0 <n:ch> up

Provision DS0 service to remote.

connect <n:ch> <n:ch>
disconnect <n:ch>

Provision DCS crossconnects to 
remote.

read remote <n> connections
read remote <n> rs232
read remote <n> t1
read remote <n> t1drop
read remote <n> v35

Read remote DS0 connections and 
interface settings.

Note: SDSL interface port has no 
settings to read.

add interface <"name"> <n:ch>

Create fractional interface and assign 
DS0s to be used.

set remote <n> rs232 <setting>
set remote <n> t1drop <setting>
set remote <n> v35 <setting>

Configure remote interface port to 
meet customer requirements.

connect remote <"name"> <port>
disconnect remote <"name">

Connect fractional interface to remote 
interface port.

set remote <n> config on
set ds1 <n> up

Download configuration and 
turn up service.